Clear all "New" markers Turn on extra data

Thread View Frames View Board View

Forum: BoaterTalk
Date: Jun 30 2008, 19:45 GMT
From: wwfan

	attaching pads to plastic boats?  One of the knee pads on my new Jackson fun is separating from the boat up near the flange that extends out from the cockpit rim.  Actually, it was never attached solid to begin with but has gotten to the point where I need to fix it because getting in and out of the boat is pulling it off even more.  Love the boat, just wish the right knee pad had been stuck on as good as the left.  Any advice on the best glue to use?  From threads, it sounds like aquaseal is great but may not stick to the smooth plastic surface of the boat.  Thanks in advance.

Add Message

Rough up the smooth plastic with sandpaper, then use contact cement. Turtle81 New

Spray glue makes outfitting jobs a lot quicker selmaraid New

Look for 78 or 77 by 3m. donutboy New

it must be a solvent based contact cement XXX_er New

Thanks for the good advice! <NT> wwfan New

Add Message